Search

You can find the results of your search below.

TP-Link TD-W8970 v1
151 Hits, Last modified:
95|**joseba_g**]]: >(...) >As programmer I use buspirate, however its easy to use other things, like a raspberry, or even computer motherboard. only need point f... is easy and fast. ==== Corrupted Uboot ==== Use RaspberryPI SPI programming header with POMONA clip-in programmer... -link-td-w8970-debricking/|Debricking Guide]]. BusPirate is currently not working, Pickit2 has not been tried, Olimex is not-working. ===== Failsafe mode
TP-Link TL-WR741ND
143 Hits, Last modified:
overy_for_TL_MR3020]]. I would recommend you use Raspberry Pi for TFTP server. And you need to connect to serial pins with USB to uart module, there are lots of chea... must be quick, or the router will continue bootlooping. ==== WR741ND V2.x ==== <code> ar7240> setenv ... this project on [[https://forum.openwrt.org/viewtopic.php?id=43237|OpenWrt forum]] * An article (in
TP-Link TL-WPA8630P v2
79 Hits, Last modified:
on/Coreboot-ThinkPads/wiki/Hardware-Flashing-with-Raspberry-Pi|Raspberry Pi]]) * ''flashrom'' >= 1.2 Instructions: * Sep... e"). You can also use a 3.3V UART on an SBC (e.g. Raspberry Pi), but it might be inconsisent when capturing early U-Boot. ^ J1 pin ^ | VCC (3.3v) | | GND | | RX | | TX (square) | ... (fill) nm - memory modify (constant address) ping - send ICMP ECHO_REQUEST to network host printe
TP-Link Archer MR200 v1
24 Hits, Last modified:
ery is possible by using a CH340a Programmer or a Raspberry Pi, SOIC8 connector/adapter is required, refer to **... rom the board. SOIC8 Adapter is required. **For Raspberry Pi** | Flash Pin | Meaning | Raspberry Pi | | 1 | CS | 24 | | 2 | DO | 21 ... ions between the flash chip and the programmer or Raspberry Pi, refer to **Connecting to Flash Chip** for more i
  • Last modified: 2024/01/03 12:05
  • by aparcar