You can find the results of your search below.

15 Hits, Last modified:
/home/evan.wu/project/ex3000-buildroot.git/build_dir/linux-ex3000/ralink-wifi-drivers/rt2860v2_ap/../rt2860v2/ap/ap_data.c... 55.0 WAN: WAN status: Link down WAN status: Link down WAN/LAN is NOT conflicting! Lease of obtained, lease time 43... . ============================================ Ralink UBoot Version: --------------------------
NETGEAR R7800 (Nighthawk X4S AC2600)
67 Hits, Last modified:
erating systems change the IP rather quickly to a link-local 196.254.x.x address if there is no DHCP ser... == Info ==== ^ Architecture | ARMv7 Processor rev 0 (v7l), arm_cortex-a15_neon-vfpv4 | ^ Vendor ... /proc/cpuinfo Processor : ARMv7 Processor rev 0 (v7l) processor : 0 BogoMIPS : 12.... fs:/overlay on / type overlayfs (rw,relatime,lowerdir=/,upperdir=/overlay) debugfs on /sys/kernel/debug
81 Hits, Last modified:
U-Boot 1.1.3 (Aug 22 2018 - 14:51:38) Board: Ralink APSoC DRAM: 128 MB relocate_code Pointer at: 87f... ============================================ Ralink UBoot Version: --------------------------... Registered protocol family 16 release PCIe RST: RALINK_RSTCTRL = 7000000 PCIE PHY initialize ***** Xtal 40MHz ***** start MT7621 PCIe register access RALINK_RSTCTRL = 7000000 RALINK_CLKCFG1 = 77ffeff8 ****
41 Hits, Last modified:
s * If you have no time to write certain stuff, link to [[docs:start]] * [[docs:guide-user:base-syst... >> Standard size for photos: add ?400 to the medialink */ /* When uploadi... is registered. sps:sps is ready. msm_pcie_setup: link initialized PCI host bridge to bus 0000:00 pci_bu... t back to back transfers disabled msm_pcie_setup: link initialized PCI host bridge to bus 0000:02 pci_bu
41 Hits, Last modified:
03 2012 - 13:04:31) CPU: AMCC PowerPC APM82181 Rev. E at 1000 MHz (PLB=166, OPB=83, EBC=83 MHz) ... es (cached) 256k L2-cache enabled PCIE0: Checking link... PCIE0: Device detected, waiting for link... PCIE0: link is up ! PCI host bridge /plb/pciex@d00000000 (primary) ranges: MEM 0x0000000e00000000..
33 Hits, Last modified:
ed chip revision. There is no driver for BCM43236 rev1 + rev2 - see comment at [ t does not remember after reboots) <code> burn_hw_rev burn5gpass burn5gssid burnboardid burnethermac bu
  • Last modified: 2022/04/24 10:04
  • by hauke