Search

You can find the results of your search below.

Xiaomi Redmi Router AC2100 @toh:xiaomi
48 Hits, Last modified:
>> Standard size for photos: add ?400 to the medialink */ /* When uploadi... ============================================== RALINK_GPIOMODE = ad428 GPIO0~31 DIR = 40 GPIO0~31 DATA = fff41517 Set gpio_4,3 direction to input Set gpio_10,6 direction to output GPIO0~31 DIR = 440 GPIO0~31 DATA = fff41517 Set gpio_6 outpu
TP-Link TD-W8970 v1 @toh:tp-link
95 Hits, Last modified:
====== TP-Link TD-W8970 v1 ====== {{ media:tplink:td-w8970:td-w8970-v1.png?200|TD-W8970 v1.0}} The TD-W8970 v1 is a ... ware:soc:soc.lantiq|Lantiq]]'' SoC. The [[toh:tp-link:tp-link_td-w8970_v3.0|TD-W8970 v3]] is a Broadcom router which is not supported by OpenWrt. The TD-W89
Huawei EchoLife HG556a @toh:huawei
43 Hits, Last modified:
with a totally different board, equiped with a Ralink wifi chip, and worse quality (no metal shieldings... t is **recomendable to put a heat sink over the Ralink wifi chip** to avoid overheating (some users repo... _data partition into it, example: >''mount /dev/sda1 /mnt'' >''dd if=/dev/mtd4 of=/mnt/hg556a-cal_data... MX29GL128EH | | **C** | **HG56BZRB VER.A** | Ralink RT3062F | HG556**<color crimson>C</color>**VDFA
Netgear R7500 @toh:netgear
46 Hits, Last modified:
s25fl512s m25p80 spi5.0: pm25lv512 (64 Kbytes) ata1: SATA link down (SStatus 0 SControl 300) UBI: attaching mtd6... 00-0x2900017f] port 0x100 irq 26 [ 4.926138] ata1: SATA link down (SStatus 0 SControl 300) [ 4.932691] ehci... 400000.ethernet eth1: configuring for fixed/sgmii link mode [ 7.605180] ipq806x-gmac-dwmac 37400000.ethernet eth1: Link is Up - 1Gbps/Full - flow control off [ 7.6129
Netgear R7800 (Nighthawk X4S AC2600) @toh:netgear
68 Hits, Last modified:
== Info ==== ^ Architecture | ARMv7 Processor rev 0 (v7l), arm_cortex-a15_neon-vfpv4 | ^ Vendor | Netgear | ^ Bo... re" 0x000007900000-0x000007980000 : "crashdump" ata1: SATA link down (SStatus 0 SControl 300) 0x000007980000-0x00... 00-0x2900017f] port 0x100 irq 26 [ 5.497002] ata1: SATA link down (SStatus 0 SControl 300) [ 5.502597] ehci... k [ 7.388161] IPv6: ADDRCONF(NETDEV_UP): eth1: link is not ready Press the [f] key and hit [enter] to
Turris CZ.NIC Omnia @toh:turris
40 Hits, Last modified:
nsole. - Insert the USB drive and mount it: ''mkdir /mnt; mount /dev/sda1 /mnt''. - Flash the OpenWrt image to eMMC: ''dd... registered f10a3800.rtc as rtc0 [ 4.571046] ata1: SATA link down (SStatus 0 SControl 300) [ 4.576488] ata2... f0000.usb3: xHCI Host Controller [ 1.290825] ata1: SATA link down (SStatus 0 SControl 300) [ 1.296072] xhci... 030000.ethernet eth1: configuring for fixed/rgmii link mode [ 8.748678] IPv6: ADDRCONF(NETDEV_UP): et
ASUS WL-500g Premium @toh:asus
38 Hits, Last modified:
3147776 7913471 2382848 83 Linux mkdir -p /mnt/sda1-overlay #won't be used afterwards, just as reminder mkdir -p /mnt/sda2-swap #won't be used afterwards, just as reminder mkdir -p /mnt/sda3-data mkswap /dev/sda2 # [[docs:gui... -drives]] opkg install e2fsprogs mkfs.ext2 /dev/sda1 mkfs.ext2 /dev/sda3 #now pivot overlay #[[docs:g
Ubiquiti EdgeRouter Lite @toh:ubiquiti
21 Hits, Last modified:
ted to be able to work with them. <code bash> $ mkdir kernel $ mount /dev/sdb1 kernel $ mkdir root $ mount /dev/sdb2 root $ mkdir oroot $ mount sysupgrade-erlite/root oroot -o loop </code> Now we... evice 0: Vendor: Prod.: USB DISK 2.0 Rev: PMAP Type: Removable Hard Disk
Linksys EA4500 v1, v2 / E4200 v2 @toh:linksys
33 Hits, Last modified:
(mtdparts) root=/dev/ram rw; bootm ${loadaddr}' mkdir /sda1 && mount /dev/sda1 /sda1 (no mistake it does not boot without it... Login using telnet/ssh and rum Commands: <code> mkdir /sda1 && mount /dev/sda1 /sda1 && cd /sda1 ubiformat /dev/mtd3 && ubiformat /dev/mtd3 -f ope... outer is booting up. The router white LED shall blink rapidly and that's when you cut the power--induci... 4745.64k 40264.68k 71031.47k 89935.47k sha1 2286.73k 6357.91k 13247.40k
Linksys EA3500 @toh:linksys
32 Hits, Last modified:
(mtdparts) root=/dev/ram rw; bootm ${loadaddr}' mkdir /sda1 && mount /dev/sda1 /sda1 (no mistake it does not boot without it... Login using telnet/ssh and run commands: <code> mkdir /sda1 && mount /dev/sda1 /sda1 && cd /sda1 ubiformat /dev/mtd3 && ubiformat /dev/mtd3 -f ope... overnor ladder [ 0.049715] Kirkwood: MV88F6282-Rev-A1. [ 0.049894] Feroceon L2: Enabling L2 [ 0.0... net0-port@0: local-mac-address is not set [ 0.050554] [Firmware Info]: /ocp@f1000000/ethernet-contro
Cisco ON-100 k9_v01/_v02 @toh:cisco
28 Hits, Last modified:
ata1: SATA max UDMA/133 irq 32 [ 2.401338] ata1: SATA link down (SStatus 0 SControl F300) [ 2.418614] i... 422325] mv643xx_eth_port mv643xx_eth_port.0 eth0: link up, 1000 Mb/s, full duplex, flow control disabled... 432232] mv643xx_eth_port mv643xx_eth_port.0 eth0: link down [ 11.472807] device eth0 entered promisc... [ 11.482013] IPv6: ADDRCONF(NETDEV_UP): br-lan: link is not ready [ 14.542372] mv643xx_eth_port mv
Netgear WNDR4700 and WNDR4720 @toh:netgear
45 Hits, Last modified:
rtc/hctosys.c: unable to open rtc device (rtc0) ata1: SATA link up 3.0 Gbps (SStatus 123 SControl F0300) ata1.00: ATA-9: WDC WD20EFRX-68AX9N0, 80.00A80, max UDMA/133 ata1.00: 3907029168 sectors, multi 0: LBA48 NCQ (depth 1/32) ata1.00: configured for UDMA/133 blk_queue_max_hw_segm
TP-Link Archer VR200 / VR200v @toh:tp-link
44 Hits, Last modified:
[ 11.719909] IFX DEU MD5 initialized. [ 11.723505] IFX DEU SHA1_HMAC initialized. [ 11.727572] IFX DEU MD5_HMAC... * [ 24.866456] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready [ 24.895056] br-lan: port 1(eth0.1) entered blocking state [ 24.899090] br-lan: port ... [ 24.945636] IPv6: ADDRCONF(NETDEV_UP): br-lan: link is not ready [ 27.971849] lantiq,xrx200-net 1e1
Huawei B593u-12 @toh:huawei
62 Hits, Last modified:
| Boardtype "0x053d", Boardnum "1234", Boardrev "0x1301"| ^ [[docs:techref:hardware:soc|System-O... 0 </code> <code># ifconfig -a br0 Link encap:Ethernet HWaddr F8:01:13:C2:19:73 ... (38.6 KiB) TX bytes:14080 (13.7 KiB) br1 Link encap:Ethernet HWaddr 00:00:00:00:00:00 ... bytes:0 (0.0 B) TX bytes:90 (90.0 B) eth0 Link encap:Ethernet HWaddr F8:01:13:C2:19:73
ZyXEL NBG6515 AC750 @toh:zyxel
58 Hits, Last modified:
eeprom-for-wifi/55787]] * WLAN works with the RaLink driver: rt2x00 in conjunction with data from the ... ayfs is functional, create a new directory by ''mkdir /root/testdir'', then ''reboot'' and verify that the directory you created is still there by ''ls -l /... | ^ Bootloader | Ralink UBoot ver: 4.0.1.0 / ELX UBoot ver: 4.0.1.6 (Jan
D-Link DCH-G020 A1 @toh:d-link
53 Hits, Last modified:
ZTE ZXHN H268A @toh:zte
45 Hits, Last modified:
  • Last modified: 2020/12/09 22:33
  • by hauke