Search

You can find the results of your search below.

D-Link DIR-885L
235 Hits, Last modified:
Wrt firmware image only supports hardware version A1 of the D-Link DIR-885L. However, the OpenWrt firmware can be used w... nWrt firmware on the A2 hardware version of the D-Link DIR-885L: - Install pre-built OpenWrt firmware image for D-Link DIR-885L. - Configure OpenWrt **LAN** and **WAN** I... e default OpenWrt network configuration for the D-Link DIR-885L. ^ Interface Name ^ Description
D-Link DIR-3060 A1
161 Hits, Last modified:
====== D-Link DIR-3060 A1====== {{page>meta:infobox:construction&noheader&nofooter&noeditbtn}} The D-Link DIR-3060... h", "deviceid"], "filterColumns": {"brand": "^D-Link$", "model": "^DIR-3060$", "version": "^A1$"} } --> /* If no unsupported functions known, c... ted_functions"], "filterColumns": {"brand": "^D-Link$", "model": "^DIR-3060$", "version": "^A1$"} } --> */ ===== Hardware Highlights ===== <!--... m", "usbports"], "filterColumns": {"brand": "^D-Link$", "model": "^DIR-3060$", "version": "^A1$"} } --> ===== Installation ===== /* stable rel
D-Link DIR-505
116 Hits, Last modified:
====== D-Link DIR-505 ====== //Write a short, relevant description of the device. Include a technical overview,... el ^ Model Specific Notes ^ | DIR-505 A1 | No "Charge Mode" | |... so far there are four versions of the dlink 505: DIR-505 A1, DIR-505L A1, DIR-505 A2, DIR-505L A2. They differ a bit on the "outer... Linux 10: For the [[https://forum.openwrt.org/t/dlink-dir-505-installation-sucessful-but-oem-fw-starts/52322|DI
D-Link DIR-825
138 Hits, Last modified:
rt.org/changeset/35403|r35403]], Also see [[toh:d-link:dir-835_a1|DIR-835]] | | C2 | same as C1?... iki.com|Wikidevi]] ([[https://deviwiki.com/wiki/D-Link_DIR-825_rev_E1|E1]], [[https://deviwiki.com/wiki/D-Link_DIR-825_rev_G1|G1]], and [[https://deviwiki.com/wiki/D-Link_DIR-825|more]]). ===== Installation ===== <!-- ToH: { "source": "json", "dom": "t", "pagin... oubleshooting:failsafe_and_factory_reset]]. ^ D-Link DIR-825 Rev B Flash Layout
D-Link DCH-G020 A1
53 Hits, Last modified:
tocol family 16 [ 0.118409] MIPS: machine is D-Link DCH-G020 Rev. A1 [ 0.384124] i2c-gpio i2c-gpio.0: using pins 0 ... 0.706777] 0x000000ed0000-0x000000f50000 : "mydlink" [ 0.714756] 0x000000f50000-0x000000fd0000 : "data1" [ 0.722586] 0x000000fd0000-0x000000ff0000 : "... - [ 4.299938] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready Press the [f] key and hit [enter] to
  • Last modified: 2024/01/03 12:05
  • by aparcar