Search
You can find the results of your search below.
Fulltext results:
- Ubiquiti UniFi AC HD
- case is held together by 6 plastic clips and some glue all around the edge. Carefully cut all around through the glue with a sharp knife, then pry the case open and ... not fully attached due to the excessive amount of glue that was used in production. Remove the glue and fully attach them if necessary. Also, when removin
- Ubiquiti NanoBeam AC
- 2AC-13 boards) **2WA** board isn't supported (or unknown support). Note: older [[toh:ubiquiti:nanobeam|Na... gcc version 4.8.3 (OpenWrt/Linaro GCC 4.8-2014.01 unknown) ) #1 Thu Jan 18 13:19:18 EET 2018 [ 0.000000]... heros/multi-bss) [ 13.330000] __ath_attach: Set global_scn[0] [ 13.330000] ACBKMinfree = 48 [ 13... gcc version 4.8.3 (OpenWrt/Linaro GCC 4.8-2014.01 unknown) ) #1 Thu Aug 22 16:38:56 EEST 2019 [ 0.000000
- Ubiquiti EdgeRouter Pro
- low for details) - Create a USB Drive with a single FAT32 partition (32MB should be adequate). - D... Support and Help Center]] to USB Drive with a single FAT32 partition. \\ //On a Linux system, you can... rtition 2 2.00 MiB mmcblk0: p1 p2 mmcblk0boot1: unknown partition table mmcblk0boot0: unknown partition table kjournald starting. Commit interval 5 seconds EXT3
- Ubiquiti Powerbeam 5AC
- gcc version 4.8.3 (OpenWrt/Linaro GCC 4.8-2014.01 unknown) ) #1 Fri Nov 18 19:18:01 EET 2016 [ 0.000000]... heros/multi-bss) [ 12.355000] __ath_attach: Set global_scn[0] [ 12.356000] ACBKMinfree = 48 [ 12... 0.4 loaded (major 251) [ 0.365218] pinctrl-single 1804002c.pinmux: 544 pins, size 68 [ 0.372597... 74201] ath10k_pci 0000:00:00.0: NOTE: Firmware DBGLOG output disabled in debug_mask: 0x10000000 [ 2
- Ubiquiti RouterStation Pro
- quashfs-factory.bin </code> If this results in an unknown command error, "TFTP Client" needs to be enabled ... * 7W while passing 1000Mbps traffic * Single RJ45 "J1" is for WAN and 802.3af compatible Powe... OE up to 25W 3. Ethernet Interface * J1 Single WAN port 10/100/1000 * J2 Tripple LAN Port 1... | Pin14 | 3.3VDC | USER GPIO Header "J33" Single Row 7 Pin Header Also next to it J5 dual row hea
- Ubiquiti LiteBeam 5AC Gen2
- gcc version 4.8.3 (OpenWrt/Linaro GCC 4.8-2014.01 unknown) ) #1 Wed Apr 25 08:50:18 EEST 2018 [ 0.000000... heros/multi-bss) [ 11.991000] __ath_attach: Set global_scn[0] [ 11.991000] ACBKMinfree = 48 [ 11... ne registered (default) [ 0.358674] pinctrl-single 1804002c.pinmux: 544 pins at pa b804002c size 68
- Ubiquiti LiteAP AC
- gcc version 4.8.3 (OpenWrt/Linaro GCC 4.8-2014.01 unknown) ) #1 Mon Feb 3 13:02:58 EET 2020 [ 0.000000] ... heros/multi-bss) [ 13.325000] __ath_attach: Set global_scn[0] [ 13.325000] ACBKMinfree = 48 [ 13
- Ubiquiti Nanostation AC
- gcc version 4.8.3 (OpenWrt/Linaro GCC 4.8-2014.01 unknown) ) #1 Fri Oct 6 14:21:30 EEST 2017 [ 0.000000]... heros/multi-bss) [ 12.237000] __ath_attach: Set global_scn[0] [ 12.237000] ACBKMinfree = 48 [ 12
- Ubiquiti Nanostation AC loco
- gcc version 4.8.3 (OpenWrt/Linaro GCC 4.8-2014.01 unknown) ) #1 Tue Oct 17 17:26:22 EEST 2017 [ 0.000000... heros/multi-bss) [ 12.043000] __ath_attach: Set global_scn[0] [ 12.043000] ACBKMinfree = 48 [ 12