Search

You can find the results of your search below.

Linksys WRT54G, WRT54GL and WRT54GS
25 Hits, Last modified:
====== Linksys WRT54G, WRT54GL and WRT54GS ====== {{section>meta:infobox:432_warning#infobox_for_data... cm-2.4/openwrt-brcm-2.4-squashfs.trx]]. === WRT54GL === Testing with the WRT54GL 1.1 (16MB RAM, 4MB flash) showed it can run the following versions: ^ ... iewtopic.php?id=51729|Forum Thread]] As the WRT54GL has only 4Mb flash, any image sent to the device
Linksys WRT54G/GL/GS GPIO @toh:linksys:wrt54g
20 Hits, Last modified:
====== Linksys WRT54G/GL/GS GPIO ====== | Please cf. the generic wikipage for [[docs:techref:hardware:... | (Output) | WLAN LED | Unknown | Not used | | GPIO 1 | O... | WHITE LED | DI (only v4.0+/WRT54GL) | | GPIO 3 | Output | ADM_EESK | ... O | | GPIO 5 | Output | ADM_EEDI | Unknown, robo_reset? | DI (only up to v3.1) | | GPIO
Linksys WAG54G2 v1.0
16 Hits, Last modified:
Flash is a [[http://www.spansion.com/products/S29GL032N.html|Spansion S29GL032N]] ( MirrorBit, 32Mb, 110nm). Spansion was a joint venture between AMD and... 4, 32 byte lines, 64 sets Machine: Solos CX46xx, unknown variant Memory policy: ECC disabled, Data cache w... /rcS' mkdir: Cannot create directory `/etc/dnrd': Unknown error 30 led: module license 'Proprietary' taints
Linksys RTP300 and WRTP54G Explored
10 Hits, Last modified:
e file as a firmware. * Bytes 0x04 through 0x07 unknown, set to 0x00010000 in most firmwares * Bytes 0x... rID set to 0x40302010 * Bytes 0x1C through 0x1F unknown, set to 0x0B010000 * Bytes 0x20 through 0x23 fi... rt of partition table * Bytes 0x2c through 0x30 unknown, set to 0xFFFFFFFF * The 0x40 bytes starting 0x... tes for fpr actual partition length * 4 bytes unknown (contain value 0xFFFFFFFF) * 4 bytes for litt
Linksys WRT610N
9 Hits, Last modified:
or VLANs) ==== Switch port numbers are currently unknown. ==== Buttons ==== Available buttons are curren... NIC Extension (NICE) ver. 8.3.14 (11/2/05) PHY ID unknown, assume it is a copper PHY. eth0: Broadcom BCM478... mem 18010000, IRQ 5, node addr 002129c66100 eth0: Unknown transceiver found eth0: Scatter-gather ON, 64-bit... ] Update [0xfb54] to [0xfb54] cmd=[misc -t get_pa5gla0idxval -w 3 ] type = [get_pa5gla0idxval] ctmisc_
Linksys E5600
8 Hits, Last modified:
gcc version 4.8.3 (OpenWrt/Linaro GCC 4.8-2014.04 unknown) ) #1 SMP Wed Jul 22 08:01:36 CST 2020 The CPU ... 0 RX_CRX_IDX0 = 3ff RX_DRX_IDX0 = 0 set_fe_HSDMA_glo_cfg HSDMA_GLO_CFG = 465 Serial: 8250/16550 driver, 16 ports, IRQ sharing enabled serial8250: ttyS0 a... AND device: Manufacturer ID: 0xef, Chip ID: 0xf1 (Unknown NAND 128MiB 3,3V 8-bit), 128MiB, page size: 2048,
Linksys E1200 v2
8 Hits, Last modified:
d=[insmod ctf ] Needed modules: et wl ip6table_mangle ip6table_filter ip6t_rt ip6t_frag ip6t_ipv6heade... mod et ] cmd=[insmod wl ] cmd=[insmod ip6table_mangle ] cmd=[insmod ip6table_filter ] cmd=[insmod ip6t... waitpid: No child processes cmd=[ip6tables -t mangle -F wlwarning2wan ] ip6tables: No chain/target/ma... c cmd=[/usr/sbin/ip -6 addr flush dev vlan2 scope global ] cmd=[ip6tables -t filter -F ] cmd=[ip6table
Linksys E900 v1
7 Hits, Last modified:
d=[insmod ctf ] Needed modules: et wl ip6table_mangle ip6table_filter ip6t_rt ip6t_frag ip6t_ipv6heade... mod et ] cmd=[insmod wl ] cmd=[insmod ip6table_mangle ] cmd=[insmod ip6table_filter ] cmd=[insmod ip6t... cmd=[/usr/sbin/ip -6 addr flush dev vlan2 scope global ] cmd=[ip6tables -t filter -F ] cmd=[ip6table... waitpid: No child processes cmd=[ip6tables -t mangle -F ] cmd=[ip6tables -t mangle -Z ] Set 0 to /pro
Linksys E8450 (aka. Belkin RT3200)
6 Hits, Last modified:
(Gary@d1r130b) (gcc version 5.4.0 (LEDE GCC 5.4.0 unknown) ) #0 SMP PREEMPT Wed Aug 26 11:31:35 UTC 2020 [ ... ck_down: RFlockDown Enable [ 28.733948] MtSingleSkuLoadParam: RF_LOCKDOWN Feature ON !!! MtSingleSkuLoadParam: SKU Table index = 1 mt7622_check_RF_l... t_thermal_protection_criteria_proc: fgHighEn: 1, fgLowEn: 1, fgRFOffEn: 1, cHighTempTh: 120, cLowTempT
Linksys EA6350 v3
6 Hits, Last modified:
outer on LAN. The above method can be used to toggle between the two firmwares. To perform a Factory... using above method. ==== Recovery (Manual) ==== Unknown. Generic u-boot tftp client method to restore fi... apter. Regular 2.1 x 5.5mm barrel plug. Use single core copper wire (eg. 2.5mm 'Twin & Earth' cable... 0 [ 0.210922] tcsr 1949000.tcsr: setting wifi_glb_cfg = 41000000 [ 0.210980] tcsr 1957000.tcsr:
Linksys e2500 v3
6 Hits, Last modified:
hernet ports (not working at this time), and a single 10/100 WAN port. ===== Supported Versions ====... ing default 5G high PA1 value cmd=[misc -t get_pa5gla0idxval -w 3 ] Change to pa2ga1idxval = 8 0xff34 ... ry_code = EU unused_offset=de cmd=[misc -t get_pa5gla1idxval -w 3 ] Change to "bootnpa2ga1idxval = 8 0xff34 0x131a 0xfb45 v get pa5gla1idxpa5ga0idxval = 10 0xfe80 0x1369 0xfb16 val" p
Linksys EA7300 v1
5 Hits, Last modified:
AND device: Manufacturer ID: 0xc2, Chip ID: 0xf1 (Unknown NAND 128MiB 3,3V 8-bit) [NAND]select ecc bit:4, s... orts. [utopia] Not setting ppp_clamp_mtu wifi, SingleSKU: /etc/7615_SingleSKU.dat_FCC, SingleSKUBF: /etc/7615_SingleSKU_BF.dat_FCC wifi cache: saving wl0 physical settings wif
Linksys WRT3200ACM
4 Hits, Last modified:
AND device: Manufacturer ID: 0xef, Chip ID: 0xda (Unknown NAND 256MiB 3,3V 8-bit), 256MiB, page size: 2048,... d1fc08c]]. * If you have multiple SSIDs on a single radio, you may encounter issues with the radio n... g/t/wrt3200acm-21-02-0-rc4-multiple-wifis-on-a-single-radio/103515/3|Forum discussion]] Reset wireles... operly. It is disabled by default. * It is strongly recommended to use auto or channel 36 on radio0
Linksys WAG54G
4 Hits, Last modified:
v3_info|WAG54Gv3]] | TNETD7200 | N/A | unknown | **Code Pattern:** WAA2 | ===== S... e is a JTAG connector next to the serial - pinout unknown. The device has a button marked "Secure Easy Set... ^ System-On-Chip | TI TNETD7300GDU (AR7WRD) Single Chip Network Processor/AFE/Line Driver | ^ CPU S... | None | | eth1 | Unknown | Disabled | | wlan0
Linksys E2500 v1
4 Hits, Last modified:
s chip. It has 4, 10/100 ethernet ports, and a single 10/100 WAN port. {{section>meta:infobox:broadc... ly bus registered [ 0.000000] MIPS: machine is Unknown Board [ 0.000000] bcm47xx: Setting up vectored... m. [ 0.540000] bcma: bus0: PMU resource config unknown or not needed for device 0x5357 [ 0.540000] bcma: bus0: Workarounds unknown or not needed for device 0x5357 [ 0.540000] bc
Linksys WRT54G3GV2-VF
4 Hits, Last modified:
Linksys EA7500 V1
4 Hits, Last modified:
Linksys WHW01 v1
3 Hits, Last modified:
Linksys WAG354G
3 Hits, Last modified:
  • Last modified: 2022/04/24 10:04
  • by hauke