Search

You can find the results of your search below.

Fulltext results:

Setting up Wi-Fi repeaters with multiple SSIDs with separated private, tor and guest network @docs:guide-user:network:wifi
6 Hits, Last modified:
ed' list icmp_type 'bad-header' list icmp_type 'unknown-header-type' list icmp_type 'router-solicitation... ed' list icmp_type 'bad-header' list icmp_type 'unknown-header-type' option limit '1000/sec' option fam... ed' list icmp_type 'bad-header' list icmp_type 'unknown-header-type' list icmp_type 'router-solicitation... ed' list icmp_type 'bad-header' list icmp_type 'unknown-header-type' option limit '1000/sec' option fam
Network configuration /etc/config/network
4 Hits, Last modified:
Enable IGMP snooping | Unconfirmed if can be set. Unknown how it interacts with interface- or port-level IG... | boolean | no | 0 | | Unconfirmed if can be set. Unknown how it interacts with interface- or port-level IG... Enable IGMP snooping | Unconfirmed if can be set. Unknown how it interacts with interface- or switch-level ... | boolean | no | 0 | | Unconfirmed if can be set. Unknown how it interacts with interface- or switch-level
Wi-Fi on/off buttons @docs:guide-user:network:wifi
4 Hits, Last modified:
lready to system shutdown function * **help** = unknown, but I see it in the source code of some devices * **phone** = unknown, but I see it in the source code of some devices * **BTN_0** = unknown, but I see it in the source code of some devices * **BTN_1** = unknown, but I see it in the source code of some devices
mwan3 (Multi WAN load balancing/failover) @docs:guide-user:network:wan:multiwan
3 Hits, Last modified:
network. Any attempts to use such services from "unknown" IP addresses will likely result in the traffic b... etwork and block any attempt of sending mail from unknown IP addresses. You will have to ensure mail traffi... ne has the masquerading active, for reasons (yet) unknown the traffic from the internal lan to the vpn will
B.A.T.M.A.N. / batman-adv @docs:guide-user:network:wifi:mesh
2 Hits, Last modified:
B mesh local PS mode: ACTIVE mesh peer PS mode: UNKNOWN mesh non-peer PS mode: ACTIVE authorized: yes ... LTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000 link/eth
OpenWrt as client device
1 Hits, Last modified:
w be accessible at the IP you set above (or at an unknown dynamic IP if you used "**DHCP client option**"),
Tunneling interface protocols
1 Hits, Last modified:
ne)// | enable/disable entering unknown source link layer addresses and IP addresses into
IPv6 configuration @docs:guide-user:network:ipv6
1 Hits, Last modified:
t, but lan machines get "Destination unreachable: Unknown code 5" or "Source address failed ingress/egress
IPv6 troubleshooting @docs:guide-user:network:ipv6
1 Hits, Last modified:
: * ULA assignment enabled: on some devices for unknown reasons, causes outbound IPv6 connectivity to fai
Identify Wi-Fi connection as metered on Windows automatically @docs:guide-user:network:wifi
1 Hits, Last modified:
When ''NetworkCostType'' is ''Unrestricted'' or ''Unknown'' and everything else is ''False'', connection tr
The Homenet Control Protocol (HNCP) @docs:guide-user:network:zeroconfig
1 Hits, Last modified:
n were last under development in late 2016. It is unknown whether the ''hncp'' package works with modern (1
Wi-Fi Repeater using AP+STA mode @docs:guide-user:network:wifi:wifiextenders
1 Hits, Last modified:
P=3 sta_err=0 while [ $(iwinfo | grep -c "ESSID: unknown") -ge 1 ]; do let sta_err=$sta_err+1 if [ $
  • Last modified: 2025/02/06 01:25
  • by hauke