Search

Fulltext results:

TP-Link TL-WR703N

23 Hits, Last modified: 11 months ago

== Remarks === * Consider simply buying a [[toh:gl.inet:64xx|GL.iNet 6416]]. Seriously, this is likely the device you actua... ing will be working. If you try this the LED will glow purple-ish. You will have to replace U-Boot wit... USB1 and USB2 are intended to be standard right angle connectors, but will also take vertical style. ... s (Sandisk Cruzer Fit). * USB3 can be a right angle or more usually a vertical connector. Or left of

TP-Link XDR-6086

16 Hits, Last modified: 11 months ago

ending and continue. taskCheckPending(359). TASK inetd finished pending and continue. taskCheckPending... 00] Kernel command line: console=ttyS0,115200n8 loglevel=0 swiotlb=512 root=/dev/mtdblock6 rootfstype=... are" [ 0.412399] mtd_device_parse_register add global full mtd:spi0.1 [ 0.413318] Ethernet Chann... = 1 [ 8.639884] before pairB output = e [ 8.641667] after pairB output = ff [ 8.643370] before

TP-Link Archer AX23

9 Hits, Last modified: 8 weeks ago

0 RX_CRX_IDX0 = 3ff RX_DRX_IDX0 = 0 set_fe_HSDMA_glo_cfg HSDMA_GLO_CFG = 465 Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled serial8250: ttyS0 a... x_ring_mem, Status=0 === pAd = c0301000, size = 6416768 === <-- RTMPAllocAdapterBlock, Status=0 PCI C... th0 ifindex =6 eth1 ifindex =9 PpeDevRegHandler : ineterface ra0 register (0) PpeDevRegHandler : ineterf

TP-Link Archer C6 v2

8 Hits, Last modified: 5 months ago

or Board Info at: 8778ffd4 Reserving 36 Bytes for Global Data at: 8778ffb0 Reserving 128k for boot par... or Board Info at: 8778ffd4 Reserving 36 Bytes for Global Data at: 8778ffb0 Reserving 128k for boot par... link-archer-c6-v2-revert-to-stock-firmware-guide/96416?u=tmomas|Tp-Link Archer C6 V2 Revert to Stock Fir... or Board Info at: 8778ffd4 Reserving 36 Bytes for Global Data at: 8778ffb0 Reserving 128k for boot par

TP-Link TL-WR710N

8 Hits, Last modified: 11 months ago

od]] applies. * Consider simply buying a [[toh:gl.inet:64xx|GL.iNet 6416]]. Seriously, this is likely the device you actua... nd: switch0 - eth1 swconfig dev eth1 show Global attributes: enable_vlan: 0 Port 0: