| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision |
| ru:toh:tp-link:tl-wr703n [2018/02/18 18:18] – tmomas | ru:toh:tp-link:tl-wr703n [2018/02/20 20:13] – ↷ Links adapted because of a move operation |
|---|
| |
| ===== Установка ===== | ===== Установка ===== |
| - Please see [[docs:user-guide:generic.flashing]] for a generic description of the OpenWrt installation process. | - Please see [[docs:user-guide:installation:generic.flashing]] for a generic description of the OpenWrt installation process. |
| | |
| |
| ==== Failsafe mode ==== | ==== Failsafe mode ==== |
| |
| When the configuration no longer allows you to log in via any network connection (e.g. lost password), the OpenWrt failsafe mode can be entered via the single "Reset" button on the device. However, in contrast to the [[docs:user-guide:failsafe_and_factory_reset|generic failsafe instructions]], for the TL-WR703N you have to wait for ca. 12 seconds before pushing the "Reset" button after powering on the device. If the button is pushed immediately after powering on, the single blue LED will start blinking, supposedly indicating some failsafe firmware recovery mody of the embedded bootloader (not yet discovered how to use it). In this mode, the OpenWrt failsafe is not being started. Instead, wait for slightly longer than 10 seconds and - as soon as the LED starts blinking for the first time after powering on the device, push the "Reset" button for ca. 1-2 seconds. Immediately afterwards, the LED will blink rapidly (multiple Hz) and OpenWrt will be in [[docs:user-guide:failsafe_and_factory_reset|failsafe mode]]. | When the configuration no longer allows you to log in via any network connection (e.g. lost password), the OpenWrt failsafe mode can be entered via the single "Reset" button on the device. However, in contrast to the [[docs:user-guide:troubleshooting:failsafe_and_factory_reset|generic failsafe instructions]], for the TL-WR703N you have to wait for ca. 12 seconds before pushing the "Reset" button after powering on the device. If the button is pushed immediately after powering on, the single blue LED will start blinking, supposedly indicating some failsafe firmware recovery mody of the embedded bootloader (not yet discovered how to use it). In this mode, the OpenWrt failsafe is not being started. Instead, wait for slightly longer than 10 seconds and - as soon as the LED starts blinking for the first time after powering on the device, push the "Reset" button for ca. 1-2 seconds. Immediately afterwards, the LED will blink rapidly (multiple Hz) and OpenWrt will be in [[docs:user-guide:troubleshooting:failsafe_and_factory_reset|failsafe mode]]. |
| |
| ==== Back to original image ==== | ==== Back to original image ==== |
| |
| ===== Аппаратные моды ===== | ===== Аппаратные моды ===== |
| - As a beginner, you really should inform yourself about [[doc:hardware:soldering]] in general and then even obtain some experience! | - As a beginner, you really should inform yourself about [[docs:hardware:soldering]] in general and then even obtain some experience! |
| |
| Here are some interesting hardware hacks for the TL-WR703N, from the OpenWRT forum: | Here are some interesting hardware hacks for the TL-WR703N, from the OpenWRT forum: |