Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revisionBoth sides next revision
inbox:toh:wudoumi:wudoumi_wdm-k10_rev5 [2023/09/17 17:00] – [Photos] cyrevoltinbox:toh:wudoumi:wudoumi_wdm-k10_rev5 [2023/09/17 17:34] – [Opening the case] cyrevolt
Line 125: Line 125:
  
 ==== Photos ==== ==== Photos ====
- 
-{{media:wdm-k10_stickered.jpg?200|Wudoumi WDM-K10}} 
  
 {{media:wudoumi:wdm-k10:wdm-k10_covers-removed.jpg?360|covers removed}} {{media:wudoumi:wdm-k10:wdm-k10_covers-removed.jpg?360|covers removed}}
- 
 {{media:wdm-k10_pcb-sandwich.jpg?360|3 PCBs and battery side view}} {{media:wdm-k10_pcb-sandwich.jpg?360|3 PCBs and battery side view}}
- 
-<WRAP clear/> 
 {{media:wdm-k10_case-open.jpg?360|case open, PCB out}} {{media:wdm-k10_case-open.jpg?360|case open, PCB out}}
  
  
 ==== Opening the case ==== ==== Opening the case ====
 +
 +| {{:meta:icons:tango:48px-emblem-important.svg.png?nolink}} | Keep in mind that the battery is always attached, so be very careful with the PCB when using tools and working on it to avoid damage. |
  
 <WRAP BOX> <WRAP BOX>
 The case can be easily opened using plastic tools. Best start next to the WiFi icon above the LEDs, and go all around to detach the top cover. The case can be easily opened using plastic tools. Best start next to the WiFi icon above the LEDs, and go all around to detach the top cover.
  
-The bigger bottom part is held by four screws. Flip the device, then pull up the cover.+The bigger bottom part is held by four screws. Remove them, flip the device, then pull up the cover off.
  
 From now on, "bottom" refers to the side holding the battery and the boards. From now on, "bottom" refers to the side holding the battery and the boards.
Line 158: Line 155:
 The UART RX and TX pins are as marked in the photo. The UART RX and TX pins are as marked in the photo.
 </WRAP> </WRAP>
 +
 +If you want to access the UART, you will need to solder wires. Since there are so many ports you may not need, you can route them out e.g. through the compact flash card slot.
  
 ^ Serial connection parameters\\ for Wudoumi WDM-K10 | 57600, 8N1 | ^ Serial connection parameters\\ for Wudoumi WDM-K10 | 57600, 8N1 |
  • Last modified: 2023/09/21 08:41
  • by cyrevolt