Sercomm MTS S1010 (aka MTS F104)
Write a short, relevant description of the device. Include a technical overview, but avoid marketing buzzwords/useless stuff. Two to four sentences is about right. A picture is good, too. Edit the page to see how to add pictures.
OpenWrt support
Not supported.
Hardware highlights
| CPU | Ram | Flash | Network | WLAN | USB | Serial | JTag |
|---|---|---|---|---|---|---|---|
| Realtek RTL8197DL @ 700 MHz | 64 MiB | 16 MiB | 4x 10/100 | bgn | 1x 2.0 | Yes | ? |
Hardware
Info
| Architecture | Lexra |
|---|---|
| Vendor | Sercomm |
| Bootloader | ? |
| System-On-Chip | EXAMPLE Ralink RT3052 - MIPS 24K V4.12 |
| CPU/Speed | Realtek RTL8197DL 700 MHz |
| Flash-Chip | Macronix MX25L12835FMI-10G |
| Flash size | 16 MiB |
| RAM | Nanya NT5TU32M16EG-AC 64 MiB |
| Wireless | Realtek RTL8192ER/RTL8812AR Wi-Fi 802.11b/g/n 300Mbps, 2.4GHz/5GHz |
| Ethernet | Realtek RTL8197DL 10/100 Mbit/s |
| Switch | Realtek RTL8197DL |
| USB | 1x 2.0 |
| Serial | No |
| JTAG | No |
Photos
Opening the case
Describe what needs to be done to open the device, e.g. remove rubber feet, adhesive labels, screws, ...
Serial
→ port.serial general information about the serial port, serial port cable, etc.
How to connect to the Serial Port of this specific device:
Insert photo of PCB with markings for serial port
Replace EXAMPLE by real values.
| Serial connection parameters for Sercomm S1010 @@Version@@ | EXAMPLE 115200, 8N1, 3.3V |
|---|
JTAG
→ port.jtag general information about the JTAG port, JTAG cable, etc.
How to connect to the JTAG Port of this specific device:
Insert photo of PCB with markings for JTAG port
Bootlogs
OEM bootlog
COPY HERE THE BOOTLOG WITH THE ORIGINAL FIRMWARE
OpenWrt bootlog
COPY HERE THE BOOTLOG ONCE OPENWRT IS INSTALLED AND RUNNING