This is an old revision of the document!


Sagem F@ST3864OP

Under Construction!
This page is currently under construction. You can edit the article to help completing it.

Write a short, relevant description of the device. Include a technical overview, but avoid marketing buzzwords/useless stuff. Two to four sentences is about right. A picture is good, too. Edit the page to see how to add pictures.

Generic Router

Not supported.

CPU Ram Flash Network WLAN USB Serial JTag
BCM63168D0, Dual-Core @400MHz 128 MiB 128 MiB NAND 4x 1G bgn 2 x 2.0 Yes ?
Architecture BMIPS
Vendor Broadcom
Bootloader CFE
System-On-Chip BCM63168D0
CPU/Speed Core 400MHz, DDR: 400MHz, Bus: 200MHz
Flash-Chip W29N01HVSINA, TSOP1 package
Flash size 128MiB, blocksize: 64 pages, page size: 2048 bytes + 64-byte OOB data.
RAM NT5CC64M16GP-DI, DDR3 128MiB
Wireless built-in? Need more investigation
Ethernet 1x WAN, 4x LAN, all support 10/100/1000
Switch SOC built-in switch + external BCM53124SKMMLG
USB 2x USB 2.0, one front, one rear
Serial Yes, unpopulated headers, 115200-8N1
JTAG ???

Datasheets:

Other ICs on board:

Insert photo of front of the casing

Insert photo of back of the casing

Insert photo of backside label

Insert photo of PCB

FIXME Describe what needs to be done to open the device, e.g. remove rubber feet, adhesive labels, screws, ...

port.serial general information about the serial port, serial port cable, etc.

How to connect to the Serial Port of this specific device:
Insert photo of PCB with markings for serial port

FIXME Replace EXAMPLE by real values.

Serial connection parameters
for Sagem F@ST3864OP @@Version@@
EXAMPLE 115200, 8N1, 3.3V

port.jtag general information about the JTAG port, JTAG cable, etc.

How to connect to the JTAG Port of this specific device:
Insert photo of PCB with markings for JTAG port

COPY HERE THE BOOTLOG WITH THE ORIGINAL FIRMWARE


COPY HERE THE BOOTLOG ONCE OPENWRT IS INSTALLED AND RUNNING


This website uses cookies. By using the website, you agree with storing cookies on your computer. Also you acknowledge that you have read and understand our Privacy Policy. If you do not agree leave the website.More information about cookies
  • Last modified: 2024/02/14 14:42
  • by rikka0w0