NETGEAR WAX210
POE AX1800 Access Point with 1Gbits Ethernet port. WPA3 and up to 4 Wifi capability
OpenWrt support
Not supported Yet.
Hardware highlights
| CPU | Ram | Flash | Network | WLAN | USB | Serial | JTag |
|---|---|---|---|---|---|---|---|
| MediaTek MT7981B (Filogic 820) Dual-Core ARM Cortex-A53 @ 1.3GHz | 512 MB DDR4 (Single chip) | 128 MB (NAND SPI) | 1x 2.5GbE (PHY: GPY211 ou Realtek, @MDIO 0) | AX1800 MT7976C (WiFi 6) 2.4GHz: 574M 5GHz: 1201M | No | Yes (115200 8N1) | Yes (Not populated) |
Hardware
Info
| Architecture | ARMv8 (64-bit) |
|---|---|
| Vendor | Netgear |
| Bootloader | U-Boot (MediaTek SDK) |
| System-On-Chip | MediaTek MT7981B (Filogic 820) |
| CPU/Speed | 1300 MHz (Dual-Core Cortex-A53) |
| Flash-Chip | SPI-NAND |
| Flash size | 128 MiB |
| RAM | 512 MiB (DDR4) |
| Wireless | MediaTek MT7976 (AX1800 WiFi 6 802.11ax) |
| Ethernet | 1x 2.5 Gbit/s |
| Switch | Aucun (Direct PHY) |
| USB | Non |
| Serial | Yes (115200 8N1) |
| JTAG | Yes (not Populated) |
Photos
Insert photo of front of the casing
Insert photo of back of the casing
Insert photo of backside label
Insert photo of PCB
Opening the case
To Open the box :
- 3 screws from the Back
- Use a credit Card to split the bottom and top Part
- 3 Screws (2 in Corners and 1 Middle opposite side)
- Undo the 2 wifi antenna connectors
- Now pull up the PCB gently
Serial
→ port.serial general information about the serial port, serial port cable, etc.
How to connect to the Serial Port of this specific device:
From left to right VCC (DON'T USE), GND, TX, RX
| Serial connection parameters for NETGEAR WAX210 @@Version@@ | 115200, 8N1, 3.3V |
|---|
JTAG
→ port.jtag general information about the JTAG port, JTAG cable, etc.
How to connect to the JTAG Port of this specific device:
Insert photo of PCB with markings for JTAG port
Bootlogs
OEM bootlog
COPY HERE THE BOOTLOG WITH THE ORIGINAL FIRMWARE
OpenWrt bootlog
COPY HERE THE BOOTLOG ONCE OPENWRT IS INSTALLED AND RUNNING