H3C Magic NX30

The H3C Magic NX30 router is based on the Qualcomm IPQ5000 SoC. It supports two 802.11ax streams on both 2.4GHz @40MHz and 5GHz @160MHz for a combined 3000Mbps wireless speed. It offers four Ethernet ports (three LAN ports and one WAN port), along with a convenient reset button.

There are 5 versions of the H3C Magic NX30 router:

• model NX30: Public version
• model RC3000: China Telecom specific version
• model RT3000: China Mobile specific version
• model RW3000: China Unicom specific version
• model RW3010: China Unicom specific version

All above versions have exactly the same hardware, and the only difference is the version of the stock firmware (which is carrier-locked).

Support Forums TBD

TBD

TBD

TBD

TBD

TBD

→ generic.flashing.tftp

TBD

→ generic.sysupgrade

TBD

TBD

TBD

TBD

TBD

→ generic.debrick

TBD

TBD

TBD

TBD

→ failsafe_and_factory_reset

→ Basic configuration After flashing, proceed with this.
Set up your Internet connection, configure wireless, configure network settings, etc.

To enable correct operation of Wi-Fi radios, choose the country code corresponding to your country prior to setting up and enabling SSIDs.

• see country code for Wi-Fi operation.

TBD

Front:
Insert photo of front of the casing

Back:
Insert photo of back of the casing

Backside label:
Insert photo of backside label

→ Warranty

TBD

Main PCB:
Insert photo of PCB

→ port.serial general information about the serial port, serial port cable, etc.

TBD

→ port.jtag general information about the JTAG port, JTAG cable, etc.

How to connect to the JTAG Port of this specific device:
Insert photo of PCB with markings for JTAG port

→ bootloader

See also information on custom bootloader bl-ipq5000