Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| inbox:toh:actiontec:f2250 [2022/01/30 05:33] – [OpenWrt bootlog] kenballus | inbox:toh:actiontec:f2250 [2022/01/30 16:41] – [Official Firmware] kenballus | ||
|---|---|---|---|
| Line 39: | Line 39: | ||
| The GPL sources are pretty straightforward to build; just ensure that you have 32-bit libs installed and everything should go smoothly. | The GPL sources are pretty straightforward to build; just ensure that you have 32-bit libs installed and everything should go smoothly. | ||
| - | It's recommended to build the GPL sources in a VM or a chroot because they will chmod -R 777 your /opt, which will break a lot of programs that use install to /opt. | + | It's recommended to build the GPL sources in a VM or a chroot because they will chmod -R 777 your /opt, which will break a lot of programs that install to /opt. |
| [[https:// | [[https:// | ||
| Line 109: | Line 109: | ||
| ===== Hardware ===== | ===== Hardware ===== | ||
| ==== Info ==== | ==== Info ==== | ||
| - | ^ Architecture | + | ^ Architecture |
| - | ^ Vendor | + | ^ Vendor |
| - | ^ Bootloader | + | ^ Bootloader |
| - | ^ System-On-Chip | + | ^ System-On-Chip |
| - | ^ CPU/ | + | ^ CPU/ |
| - | ^ Flash-Chip | + | ^ Flash-Chip |
| - | ^ Flash size | + | ^ Flash size |
| - | ^ RAM | EXAMPLE 64 MiB | | + | ^ RAM | 128 MiB | |
| - | ^ Wireless | + | ^ Switch |
| - | ^ Ethernet | + | ^ USB | 1x 2.0 | |
| - | ^ Switch | + | ^ Serial |
| - | ^ USB | EXAMPLE | + | |
| - | ^ Serial | + | |
| - | ^ JTAG | EXAMPLE [[#JTAG|Not populated]] | + | |
| - | |||
| - | /*** if info available: uncomment and fill in | ||
| ==== Flash Layout ==== | ==== Flash Layout ==== | ||
| - | <WRAP BOX> | + | 0x000003da0000-0x000007ae0000 : " |
| - | FIXME //[[:docs: | + | 0x000000040000-0x000003d80000 |
| - | + | 0x000007b00000-0x000007f00000 | |
| - | Please check out the article [[docs:techref: | + | 0x000000000000-0x000000020000 : " |
| - | </ | + | 0x000003d80000-0x000003da0000 |
| - | ***/ | + | 0x000000020000-0x000000040000 : " |
| Line 220: | Line 215: | ||
| boot load image is: 48 | boot load image is: 48 | ||
| Board IP address | Board IP address | ||
| - | Host IP address | + | Host IP address |
| Gateway IP address | Gateway IP address | ||
| Run from flash/host (f/h) : f | Run from flash/host (f/h) : f | ||
| Line 645: | Line 640: | ||
| boot load image is: 48 | boot load image is: 48 | ||
| Board IP address | Board IP address | ||
| - | Host IP address | + | Host IP address |
| Gateway IP address | Gateway IP address | ||
| Run from flash/host (f/h) : f | Run from flash/host (f/h) : f | ||
| Line 671: | Line 666: | ||
| CFE> ^C | CFE> ^C | ||
| - | CFE> r 192.168.1.10:/ | + | CFE> r 192.168.1.100:/ |
| 0x80a00000/ | 0x80a00000/ | ||
| Closing network. | Closing network. | ||