Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revisionBoth sides next revision
docs:guide-user:troubleshooting:generic.debrick [2018/06/07 15:15] – links fixed tmomasdocs:guide-user:troubleshooting:generic.debrick [2018/12/19 12:54] – old revision restored (2018/09/14 19:51) per @tmomas' view jw0914
Line 41: Line 41:
  
 If you have an Arduino board you can upload a sketch that will send the debrick commands via serial. An example that works for the TP-WR703N is available here: https://forum.openwrt.org/viewtopic.php?pid=191463. Note that the commands for your router could be different! If you have an Arduino board you can upload a sketch that will send the debrick commands via serial. An example that works for the TP-WR703N is available here: https://forum.openwrt.org/viewtopic.php?pid=191463. Note that the commands for your router could be different!
 +
 +=== Raspberry Pi ===
 +
 +If you don't have a USB serial ttl but have a Raspberry Pi, you can use it to connect to the router's serial pins. The Raspberry Pi's uart works at 3.3V which is the correct voltage for most routers. Connect the GND to GND, the RX to TX, and the TX to RX. Leave VCC (or 3.3V) unconnected (that is, in the end you will only be connecting 3 pins out of 4).
  
 === WIFI === === WIFI ===
  • Last modified: 2023/03/18 23:40
  • by ryanc