Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revisionBoth sides next revision
docs:guide-user:network:wan:wwan:ltedongle [2024/11/19 17:50] – [With LuCi web interface] andrewzdocs:guide-user:network:wan:wwan:ltedongle [2024/11/27 18:05] – [LTE or 5G Modem Preparation] andrewz
Line 53: Line 53:
 Replace ''IP'' with ''IPV4V6'' or ''IPV6'' if necessary and use your APN instead of ''internet''. Replace ''IP'' with ''IPV4V6'' or ''IPV6'' if necessary and use your APN instead of ''internet''.
  
-For an alternative method, see below on this page.+For an alternative method, see [[:docs:guide-user:network:wan:wwan:ltedongle]] section below.
  
 \\ \\
Line 79: Line 79:
 A //terminal// program like ''picocom'' will be needed to actually send AT commands. A //terminal// program like ''picocom'' will be needed to actually send AT commands.
  
-3. Install [[:packages:pkgdata:usb-modeswitch]] package only __if__ that is needed for switching the modem into a "working" state. More about: [[docs:guide-user:network:wan:wwan:usb-modeswitching|USB mode switch]]+3. Install [[:packages:pkgdata:usb-modeswitch]] package __only if__ that is needed for switching the modem into a "working" state. More about: [[docs:guide-user:network:wan:wwan:usb-modeswitching|USB mode switch]]
  
 4. Add support for the //storage// of your modem - refer to: [[docs:guide-user:storage:usb-drives|USB Storage]] 4. Add support for the //storage// of your modem - refer to: [[docs:guide-user:storage:usb-drives|USB Storage]]
  • Last modified: 2024/12/19 20:23
  • by andrewz