Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revisionBoth sides next revision
docs:guide-user:network:wan:wwan:ltedongle [2024/11/19 17:49] – [MBIM Protocol support] andrewzdocs:guide-user:network:wan:wwan:ltedongle [2024/11/27 18:05] – [LTE or 5G Modem Preparation] andrewz
Line 53: Line 53:
 Replace ''IP'' with ''IPV4V6'' or ''IPV6'' if necessary and use your APN instead of ''internet''. Replace ''IP'' with ''IPV4V6'' or ''IPV6'' if necessary and use your APN instead of ''internet''.
  
-For an alternative method, see below on this page.+For an alternative method, see [[:docs:guide-user:network:wan:wwan:ltedongle]] section below.
  
 \\ \\
Line 79: Line 79:
 A //terminal// program like ''picocom'' will be needed to actually send AT commands. A //terminal// program like ''picocom'' will be needed to actually send AT commands.
  
-3. Install [[:packages:pkgdata:usb-modeswitch]] package only __if__ that is needed for switching the modem into a "working" state. More about: [[docs:guide-user:network:wan:wwan:usb-modeswitching|USB mode switch]]+3. Install [[:packages:pkgdata:usb-modeswitch]] package __only if__ that is needed for switching the modem into a "working" state. More about: [[docs:guide-user:network:wan:wwan:usb-modeswitching|USB mode switch]]
  
 4. Add support for the //storage// of your modem - refer to: [[docs:guide-user:storage:usb-drives|USB Storage]] 4. Add support for the //storage// of your modem - refer to: [[docs:guide-user:storage:usb-drives|USB Storage]]
Line 158: Line 158:
  
 Enter your ''APN'' and select the ''IP type'' as instructed by the carrier, __don't set ''IP type'' to ''IPV4V6'' until you're 100% sure that provider supports IPv6__, that is critical in QMI mode. Enter your ''APN'' and select the ''IP type'' as instructed by the carrier, __don't set ''IP type'' to ''IPV4V6'' until you're 100% sure that provider supports IPv6__, that is critical in QMI mode.
 +
 +Note: in IPv6-only mode it is recommended to enable ''dhcpv6'' option on in order to automatically start the 464XLAT interface (that requires [[:packages:pkgdata:464xlat]] package).
  
 Assign the firewall zone (wan) on 'Firewall Settings' tab. Assign the firewall zone (wan) on 'Firewall Settings' tab.
  • Last modified: 2024/12/19 20:23
  • by andrewz