Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| docs:guide-user:network:wan:access.modem.through.nat [2021/03/18 05:17] – optimize description vgaetera | docs:guide-user:network:wan:access.modem.through.nat [2024/10/30 00:44] – [Web interface instructions] Easier to assign the "modem" interface to the "wan" zone. lastedit | ||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ===== Introduction ===== | ===== Introduction ===== | ||
| - | * This how-to describes the method for accessing | + | * This how-to describes the method for accessing |
| - | * You can reach the administrative interface of a DSL/DOCSIS modem to customize its settings. | + | * It helps to reach the administrative interface of a DSL/DOCSIS modem operating in the bridge mode. |
| * The prerequisite is to know the modem' | * The prerequisite is to know the modem' | ||
| Line 10: | Line 10: | ||
| * Access the modem operating in the bridge mode through the router. | * Access the modem operating in the bridge mode through the router. | ||
| - | ===== Web interface ===== | + | ===== Web interface |
| Assuming your modem' | Assuming your modem' | ||
| Line 22: | Line 22: | ||
| * IPv4 address: '' | * IPv4 address: '' | ||
| * IPv4 netmask: '' | * IPv4 netmask: '' | ||
| - | - On the **Firewall Settings** tab specify: | + | - On the **Firewall Settings** tab assign the '' |
| * Create / Assign firewall-zone: | * Create / Assign firewall-zone: | ||
| - Click **Save**, then **Save & Apply**. | - Click **Save**, then **Save & Apply**. | ||
| Line 28: | Line 28: | ||
| At this point the modem should be reachable from any host in the LAN. | At this point the modem should be reachable from any host in the LAN. | ||
| - | ===== Command-line | + | |
| + | === NOTE === | ||
| + | |||
| + | If you are using the BanIP package, make sure to add the IP to the allowlist. Ex. '' | ||
| + | |||
| + | |||
| + | ===== Command-line | ||
| Assuming your modem' | Assuming your modem' | ||
| Line 34: | Line 40: | ||
| <code bash> | <code bash> | ||
| - | # Configure firewall | ||
| - | uci add_list firewall.@zone[1].network=" | ||
| - | uci commit firewall | ||
| - | / | ||
| - | |||
| # Configure network | # Configure network | ||
| - | uci -q delete | + | uci -q del network.modem |
| uci set network.modem=" | uci set network.modem=" | ||
| - | uci set network.modem.ifname=" | ||
| uci set network.modem.proto=" | uci set network.modem.proto=" | ||
| + | uci set network.modem.device=" | ||
| uci set network.modem.ipaddr=" | uci set network.modem.ipaddr=" | ||
| uci set network.modem.netmask=" | uci set network.modem.netmask=" | ||
| uci commit network | uci commit network | ||
| - | /etc/init.d/network restart | + | service network restart |
| + | |||
| + | # Configure firewall | ||
| + | uci del_list firewall.@zone[1].network=" | ||
| + | uci add_list firewall.@zone[1].network=" | ||
| + | uci commit firewall | ||
| + | service firewall | ||
| </ | </ | ||
| Line 56: | Line 63: | ||
| uci set network.lan.ipaddr=" | uci set network.lan.ipaddr=" | ||
| uci commit network | uci commit network | ||
| - | / | + | service |
| </ | </ | ||
| Line 69: | Line 76: | ||
| # Configure network | # Configure network | ||
| - | uci set network.modem.ifname=" | + | uci set network.modem.device=" |
| uci commit network | uci commit network | ||
| - | / | + | service |
| </ | </ | ||