Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revisionBoth sides next revision
docs:guide-user:network:ipv6:ipv6.nat6 [2023/03/28 06:39] – [Troubleshooting] vgaeteradocs:guide-user:network:ipv6:ipv6.nat6 [2023/09/17 23:39] – [Introduction] vgaetera
Line 12: Line 12:
     * Creating a subnet for when the network doesn't support subnetting.     * Creating a subnet for when the network doesn't support subnetting.
     * Being provided a smaller prefix than a /64 or worse, none at all or a ULA address.     * Being provided a smaller prefix than a /64 or worse, none at all or a ULA address.
-  * Follow [[docs:guide-user:network:ipv6:nat64|NAT64]] to provide access to IPv4-only services from IPv6-only client networks.+  * See also: [[docs:guide-user:network:ipv6:nat64|NAT64]], [[docs:guide-user:firewall:fw3_configurations:fw3_nat#ipv6_npt|IPv6 NAT and NPT]]
  
 ===== Command-line instructions ===== ===== Command-line instructions =====
Line 26: Line 26:
  
 ==== 2. Network ==== ==== 2. Network ====
-Disable IPv6 source routing on the upstream interface.+Disable IPv6 source filter on the upstream interface.
  
 <code bash> <code bash>
Line 50: Line 50:
 # Persistent configuration # Persistent configuration
 uci show network; uci show firewall uci show network; uci show firewall
-</code> 
- 
-===== Extras ===== 
-==== Selective IPv6 masquerading ==== 
-Enable selective IPv6 masquerading for a specific source subnet. 
- 
-<code bash> 
-# Configure firewall 
-uci -q delete firewall.@zone[1].masq6 
-uci -q delete firewall.nat66 
-uci set firewall.nat66="nat" 
-uci set firewall.nat66.family="ipv6" 
-uci set firewall.nat66.proto="all" 
-uci set firewall.nat66.src="wan" 
-uci set firewall.nat66.src_ip="fc00::/7" 
-uci set firewall.nat66.target="MASQUERADE" 
-uci commit firewall 
-/etc/init.d/firewall restart 
 </code> </code>
  
  • Last modified: 2023/10/14 06:10
  • by vgaetera