Show pagesourceOld revisionsBacklinksBack to top × Telnet Installation can be done via Telnet. Devices with this installation method ↓ BrandModelVersionSupported Current RelInstallation method(s)Comment installationDevice PageDevice Techdata AsiaRFAP7621-001snapshotTFTP generic, Sysupgrade, Serial, Telnet, U-Boot TFTP recovery, U-Boot TFTP + serial recoveryView/Edit dataAsiaRFAP7621-00218.06.0TFTP generic, Telnet, U-Boot TFTP + serial recoveryasiarf_ap7621-002View/Edit dataEnGeniusENS202EXT1.0.019.07.6GUI OEM, Telnet, see git-commitengenius_ens202ext_1.0.0View/Edit dataGeHuaGHL-R-00119.07.0Telnet, see git-commitView/Edit datai.onikCloud Hubexternal imageSerial, Telnetlogin root/91657853, then mtd_write of sysupgrade image to mtd5View/Edit dataMedionMD86587v119.07.6Telnet, see devicepagemd86587View/Edit dataNetgearR623019.07.6Telnet, see devicepage, see git-commitLuCI Web Interface/uhttpd (also ssh) may NOT be enabled across power cycling after installation, or hard reset. If not - can test by power cycling first, a hard reset brings it back - then ssh, enter '/etc/init.d/uhttpd enable' on the command line, then 'reboot' or '/etc/init.d/uhttpd start' before power cycling or backing up a configuration. Restoring a configuration from after this had been applied also solves the problem.netgear_r6230View/Edit dataSamsungWAM25019.07.6Telnet, see git-commitView/Edit data This website uses cookies. By using the website, you agree with storing cookies on your computer. Also you acknowledge that you have read and understand our Privacy Policy. If you do not agree leave the website.OKMore information about cookies Last modified: 2019/09/14 09:06by tmomas