Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revisionBoth sides next revision
docs:user-guide:hardware:devolo-stream-radio [2018/02/17 18:48] – ↷ Page moved from docs:user-guide:hardware:usb-dongles:devolo-stream-radio to docs:user-guide:hardware:devolo-stream-radio bobafetthotmaildocs:user-guide:hardware:devolo-stream-radio [2018/02/17 19:40] – ↷ Links adapted because of a move operation
Line 30: Line 30:
 ==== IR remote controled ==== ==== IR remote controled ====
 We can control our streaming radio with a infrared remote. No special hardware required, just any spare remote (don't you have dozens from broken hardware?), and a simple circuit connected to the microphone input. More details at\\ We can control our streaming radio with a infrared remote. No special hardware required, just any spare remote (don't you have dozens from broken hardware?), and a simple circuit connected to the microphone input. More details at\\
-[[doc/howto/lirc-audio_alsa| lirc audio-alsa]]\\+[[docs:user-guide:hardware:lirc-audio_alsa| lirc audio-alsa]]\\
 However we'll use an improved circuit. With a low band pass filter to minimize power supply disturbances. Also we will put the 100 nF capacitor before the voltage divider, not after: However we'll use an improved circuit. With a low band pass filter to minimize power supply disturbances. Also we will put the 100 nF capacitor before the voltage divider, not after:
  
Line 98: Line 98:
  
 === lirc === === lirc ===
-This is the infrared daemon receiver. Has been built with the audio_alsa driver. It uses the microphone input for receiving signals from a remote. As described in [[doc/howto/lirc-audio_alsa| lirc audio-alsa]].+This is the infrared daemon receiver. Has been built with the audio_alsa driver. It uses the microphone input for receiving signals from a remote. As described in [[docs:user-guide:hardware:lirc-audio_alsa| lirc audio-alsa]].
 Here we need to configure two files. Here we need to configure two files.
   * The codes for our remote\\ ///etc/lircd.conf//   * The codes for our remote\\ ///etc/lircd.conf//
  • Last modified: 2019/09/02 13:56
  • by tmomas