Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revisionBoth sides next revision
docs:user-guide:hardware:usb-dongles:devolo-stream-radio [2018/02/17 18:47] – ↷ Page moved from doc:howto:devolo-stream-radio to docs:user-guide:hardware:usb-dongles:devolo-stream-radio bobafetthotmaildocs:user-guide:hardware:devolo-stream-radio [2018/02/17 19:40] – ↷ Links adapted because of a move operation
Line 30: Line 30:
 ==== IR remote controled ==== ==== IR remote controled ====
 We can control our streaming radio with a infrared remote. No special hardware required, just any spare remote (don't you have dozens from broken hardware?), and a simple circuit connected to the microphone input. More details at\\ We can control our streaming radio with a infrared remote. No special hardware required, just any spare remote (don't you have dozens from broken hardware?), and a simple circuit connected to the microphone input. More details at\\
-[[doc/howto/lirc-audio_alsa| lirc audio-alsa]]\\+[[docs:user-guide:hardware:lirc-audio_alsa| lirc audio-alsa]]\\
 However we'll use an improved circuit. With a low band pass filter to minimize power supply disturbances. Also we will put the 100 nF capacitor before the voltage divider, not after: However we'll use an improved circuit. With a low band pass filter to minimize power supply disturbances. Also we will put the 100 nF capacitor before the voltage divider, not after:
  
Line 98: Line 98:
  
 === lirc === === lirc ===
-This is the infrared daemon receiver. Has been built with the audio_alsa driver. It uses the microphone input for receiving signals from a remote. As described in [[doc/howto/lirc-audio_alsa| lirc audio-alsa]].+This is the infrared daemon receiver. Has been built with the audio_alsa driver. It uses the microphone input for receiving signals from a remote. As described in [[docs:user-guide:hardware:lirc-audio_alsa| lirc audio-alsa]].
 Here we need to configure two files. Here we need to configure two files.
   * The codes for our remote\\ ///etc/lircd.conf//   * The codes for our remote\\ ///etc/lircd.conf//
  • Last modified: 2019/09/02 13:56
  • by tmomas