Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| docs:guide-quick-start:sysupgrade.luci [2021/03/04 22:34] – [Check flash result] vgaetera | docs:guide-quick-start:sysupgrade.luci [2023/01/17 12:46] – [Backup] link section vgaetera | ||
|---|---|---|---|
| Line 4: | Line 4: | ||
| * If your current OpenWrt installation does not have web interface installed or if you prefer to upgrade from the command line (upgrade from command line provides more fine-grained control), refer to [[docs: | * If your current OpenWrt installation does not have web interface installed or if you prefer to upgrade from the command line (upgrade from command line provides more fine-grained control), refer to [[docs: | ||
| * If you have any questions about this description, | * If you have any questions about this description, | ||
| + | * Be aware of major config incompatibilities and version compatibility [[docs: | ||
| + | |||
| + | ===== Backup ===== | ||
| + | {{section> | ||
| ===== Locate and download the OpenWrt firmware ===== | ===== Locate and download the OpenWrt firmware ===== | ||
| Line 15: | Line 19: | ||
| ===== Verify firmware file and flash the firmware ===== | ===== Verify firmware file and flash the firmware ===== | ||
| - | - Connect to the device via Ethernet cable (Use wireless | + | - Connect to the device via Ethernet cable (Only use wireless if the device has no Ethernet connection options) |
| - Log into the web interface and in the **System -> Backup/ | - Log into the web interface and in the **System -> Backup/ | ||
| - **Uncheck**/ | - **Uncheck**/ | ||
| Line 29: | Line 33: | ||
| * if the checksum step fails repeatedly, you can consult the [[https:// | * if the checksum step fails repeatedly, you can consult the [[https:// | ||
| - | ===== Check flash result | + | ===== Post-upgrade steps ===== |
| * After your device has finished flashing and rebooting, check if you can access the LuCI web interface (or the IP that you know of). | * After your device has finished flashing and rebooting, check if you can access the LuCI web interface (or the IP that you know of). | ||
| + | * See **Post-upgrade steps** in [[docs: | ||
| Troubleshooting: | Troubleshooting: | ||
| Line 37: | Line 42: | ||
| * If you have checkmarked the "Keep settings" | * If you have checkmarked the "Keep settings" | ||
| * Otherwise you need to start configuring from scratch. In this case, remember to properly **set your country code in the OpenWrt Wi-Fi configuration** again, to comply with your country' | * Otherwise you need to start configuring from scratch. In this case, remember to properly **set your country code in the OpenWrt Wi-Fi configuration** again, to comply with your country' | ||
| - | |||
| - | See also: | ||
| - | [[docs: | ||
| - | [[docs: | ||