Table of Contents
Surecom EP-9600-gp
The Surecom EP-9600-gp is an wireless acccess point with two antennas.
The board should be the same as D-Link DWL2100AP
Supported Versions
| Version/Model | Launch Date | S/N | OpenWrt Version Supported | Model Specific Notes |
|---|---|---|---|---|
| EP-9600-gp A1 |  | - | Backfire 10.03.1 | - |
NOTE: Untested: information based on D-Link DWL2100AP.
Hardware Highlights
| SoC | Ram | Flash | Network | USB | Serial | JTag |
|---|---|---|---|---|---|---|
| Atheros AR2313A@ | 16MiB | 4MiB | 1 | No | Yes | Yes |
Installation
Please refer to D-Link DWL2100AP.
Hardware
Info
| Instruction set: | MIPS |
| Vendor: | Atheros |
| bootloader: | VxWorks |
| System-On-Chip: | Atheros AR2313A |
| CPU @Frq | |
| Flash size: | 4 MB |
| Flash Chip: | Spansion S29GL032M90TFIR4 |
| RAM size: | 16 MB |
| RAM Chip: | ESMT M12L128168A |
| Wireless: | Atheros AR2112A w/ 2 external antennas for 802.11b/g |
| switch: | IC+ IP101A |
| Modem: | none |
| USB: | No |
| Serial: | Yes |
| JTAG: | Yes |
Photos
Front:
Back:
Opening the case
Note: This will void your warranty!
- Remove two screws under the AP
- Gently unhook two latches in the front
Main PCB
Serial
→ port.serial general information about the serial port, serial port cable, etc.
Serial console could be plugged to JP1: connector lacks, it has to be soldered on the board.
For further instructions please refer to the D-link DWL-2100AP page.
The settings are: 9600 bauds, 8 bits, no parity, 1 stop bit (9600 8N1)
| terminal configuration | |
|---|---|
| Bits per second | 9600 |
| Data bits | 8 |
| Parity | None |
| Stop bits | 1 |
| Flow control | None |
JTAG
→ port.jtag general information about the JTAG port, JTAG cable, etc.
Jtag pins are located in J1, but the connector lacks. The pinout and specifications should be the same of D-link DWL-2100AP
Notes
This Access Point should use the same board as D-link DWL-2100AP; so everything on there should also apply to this model.