Meraki MR74
Write a short, relevant description of the device. Include a technical overview, but avoid marketing buzzwords/useless stuff. Two to four sentences is about right. A picture is good, too. Edit the page to see how to add pictures.
OpenWrt support
Not supported.
Hardware highlights
| CPU | Ram | Flash | Network | WLAN | USB | Serial | JTag |
|---|---|---|---|---|---|---|---|
| Qualcomm Atheros IPQ4029 @ 716 | 256 MiB | 128 MiB | 1x 100/1000 | abgn | no | Yes | ? |
Hardware
Info
| Architecture | Arm v7 |
|---|---|
| Vendor | Qualcomm |
| Bootloader | U-Boot |
| System-On-Chip | Qualcomm IPQ4029 |
| CPU/Speed | 716 MHz |
| Flash-Chip | Spansion S34ML01G200TFV00 |
| Flash size | 128 MiB |
| RAM | 256 MiB |
| Wireless | Qualcomm IPQ4029 2.4GHz + Qualcomm IPQ4029 5.0GHz + PCIe Qualcomm QCA9889 (2.4GHz & 5.0GHz) |
| Ethernet | 10/100/1000 Mbit/s POE |
| Switch | N/A |
| USB | ? |
| Serial | Yes |
| JTAG | Not populated |
Photos
Insert photo of front of the casing
Insert photo of back of the casing
Insert photo of backside label
Insert photo of PCB
Opening the case
Describe what needs to be done to open the device, e.g. remove rubber feet, adhesive labels, screws, ...
Serial
→ port.serial general information about the serial port, serial port cable, etc.
How to connect to the Serial Port of this specific device:
Insert photo of PCB with markings for serial port
Replace EXAMPLE by real values.
| Serial connection parameters for Meraki MR74 @@Version@@ | EXAMPLE 115200, 8N1, 3.3V |
|---|
JTAG
→ port.jtag general information about the JTAG port, JTAG cable, etc.
How to connect to the JTAG Port of this specific device:
Insert photo of PCB with markings for JTAG port
Bootlogs
OEM bootlog
COPY HERE THE BOOTLOG WITH THE ORIGINAL FIRMWARE
OpenWrt bootlog
COPY HERE THE BOOTLOG ONCE OPENWRT IS INSTALLED AND RUNNING